MIL-HDBK-115 Us Army Reverse Engineering Handbook Guidelines And ProceduresThis HANDBOOK, which provides the guidelines and procedures for performing reverse engineering, was created using current applicable laws and knowledge gained during a trial program from July 1985 to April 1987, and is based on experiences obtained from military and industry participants. This handbook is for guidance only and cannot be cited as a requirement.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39 - 40 - 41 - 42 - 43 - 44 - 45 - 46 - 47 - 48 - 49 - 50 - 51 - 52 - 53 - 54 - 55 - 56 - 57 - 58 - 59 - 60 - 61 - 62 - 63 - 64 - 65 - 66 - 67 - 68 - 69 - 70 - 71 - 72 - 73 - 74 - 75 - 76 - 77 - 78

MIL-HDBK-115B(ARMY) APPENDIX D

REFERENCE DOCUMENTS

D.1 SCOPE.

D.1.1 Scope. This appendix contains documents that may provide helpful information in addition to those documents listed in Section 2, Applicable Documents.

D.2 REFERENCE DOCUMENTS.

D.2.1 Reference documents. The following documents may be used as guidance for accomplishing the reverse engineering process.

D.2.1.1 Federal Specifications

GG-P-455                               Plate and Foils, Photographic (Photosensitive Anodized

Aluminum)

D.2.1.2 Federal Standards

D.2.1.3 Commercial Item Descriptions

A-A-208                                  Ink, Marking, Stencil, Opaque (Porous and Non-Porous

Surfaces)

A-A-50271                              Plate, Identification

A-A-55822                              Chests, Plywood

A-A-59544                              Cable and Wire, Electrical (Power, Fixed Installation)

D.2.1.5 Military Specifications

MIL-PRF-27                           Transformers and Inductors (Audio, Power, and High Power

Pulse), General Specification for

MIL-DTL-3432                      Cables (Power and Special Purpose) and Wire, Electrical

(300 and 600 Volts)

MIL-PRF-5480                       Data, Engineering and Technical, Reproduction, Performance Specification

MIL-G-10944                         Gage, Dimensional Control

MIL-W-12332                        Welding, Resistance, Spot, Seam, and Projection; for

Fabricating Assemblies of Low Carbon Steel

MIL-PRF-19500                     Semiconductor Device, General Specification for

MIL-W-21157                        Weldment, Steel, Carbon and Low Alloy (Yield Strength,

30,000 - 60,000 PSI)

MIL-W-22248                        Weldments, Aluminum and Aluminum Alloy

MIL-DTL-45210                    Welding, Resistance, Spot: Weldable Aluminum Alloys

MIL-DTL-19834                    Plates, Indentification or Instruction, Metal Foil, Adhesive

Backed General Specification for

56