MIL-HDBK-115 Us Army Reverse Engineering Handbook Guidelines And ProceduresThis HANDBOOK, which provides the guidelines and procedures for performing reverse engineering, was created using current applicable laws and knowledge gained during a trial program from July 1985 to April 1987, and is based on experiences obtained from military and industry participants. This handbook is for guidance only and cannot be cited as a requirement.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39 - 40 - 41 - 42 - 43 - 44 - 45 - 46 - 47 - 48 - 49 - 50 - 51 - 52 - 53 - 54 - 55 - 56 - 57 - 58 - 59 - 60 - 61 - 62 - 63 - 64 - 65 - 66 - 67 - 68 - 69 - 70 - 71 - 72 - 73 - 74 - 75 - 76 - 77 - 78

MIL-HDBK-115B(ARMY)

MIL-STD-1916 DoD Preferred Methods for Acceptance of Product

MILITARY HANDBOOKS

MIL-HDBK-1264 Radiographic Inspection for Soundness of Welds

in Steel by Comparison to

Graded ASTM E390

Reference Radiographs

MIL-HDBK-1265 Radiographic Inspection Classification and Soundness Requirements for Steel Castings

(Copies of these documents are available online at https://assist.daps.dla.mil/quicksearch or from the Standardization Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-

5094.)

2.3 Non-Government publications. The following documents form a part of this document to the extent specified herein.

INDUSTRY STANDARDS

American National Standards Institute (ANSI)

ANSI B4.1 Preferred Limits and Fits for Cylindrical Parts

AWS A2.4 Standard Symbols for Welding, Brazing, and Non-destructive Examination

AWS A3.0 Welding Terms & Definitions, Standard

AWS C3.4 Torch Brazing AWS C3.5 Brazing, Induction AWS C3.6 Furnace Brazing